Ricoh Pro L5160 안전 정보 매뉴얼 - 페이지 14

{카테고리_이름} Ricoh Pro L5160에 대한 안전 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Pro L5160 32 페이지. Additional function 2
Ricoh Pro L5160에 대해서도 마찬가지입니다: 추출 설정 매뉴얼 (44 페이지), 빠른 시작 Quide (32 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

1. Safety Information for This Machine

• If the ink cartridge is moved from a cold place to a warm place, leave it in the room temperature

for 3 hours or more before using it.

• Open the ink cartridge just before installing it in the machine. If it is opened and left for an

extended period of time, normal printing performance of the machine may not be ensured.

• Make sure to store ink cartridges in a cool and dark place.

• Be sure to thoroughly consume the ink in the ink cartridge, once it is opened, within 3 months. If

an extended period of time has passed away after opening the cartridge tank, printing quality

would be poor.

• Do not touch or stain the contacts of the ink cartridges, flushing cartridges, displacement liquid

cartridges, and cleaning cartridge, as doing so may cause damage to the print circuit board.

• Use media recommended by RICOH to ensure reliable, high-quality printing.

• Set the heater temperature to meet the characteristics of the media. Set the temperature of the

pre-heater, print heater, post-heater, and cure heater according to the type and characteristics

of the media used. Automatic temperature setting can be made on the operation panel by

setting the profile on the dedicated RIP. For setting on the RIP, see the instruction manual for your

RIP.

• Pay attention to the expansion and contraction of the media. Do not use media immediately

after unpacking. The media can be affected by the room temperature and humidity, and thus it

may expand and contract. The media have to be left in the atmosphere in which they are to be

used for 30 minutes or more after unpacked.

• Do not use curled media. The use of curled media cannot only cause a media jam but also affect

print quality. Straighten the sheet of media, if significantly curled, before using it for printing. If a

regular-sized coated sheet of media is rolled and stored, the coated side has to face outside.

• Do not leave the media with the heater ON for a long time.

• Store media in a bag. Wiping off dust accumulated on media will adversely affect the media

due to static electricity.

• When leaving the workshop after the working hours, do not leave any media on the roll holder.

If any media is left on the roll holder, it can get dusty.