Ricoh Ri 6000 안전 정보 및 빠른 설치 매뉴얼 - 페이지 19

{카테고리_이름} Ricoh Ri 6000에 대한 안전 정보 및 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Ri 6000 24 페이지. Direct to garment printers

페이지 인쇄
Ricoh Ri 6000 안전 정보 및 빠른 설치 매뉴얼

Installation Procedure

1. PREPARE PRINTER ENVIRONMENT
Reliable Power source/outlet. Consider using a UPS if your area's power is unreliable
•
•
Electronic hygrometer/thermometer (to monitor the relative humidity of the room the printer is operating in).
Keep it near the printer at all times 15°C to 32°C (59°F to 90 °F).
•
Humidifier to increase humidity if it falls below 45% humidity. Humidity needs to remain between 45% to
80% RH, non-condensing.
•
Heat Press or tunnel dryer for heat curing the ink (THIS NEEDS ITS OWN CIRCUIT)
•
Stable, Sturdy, and Level Table for the 81.6 kg (180 lb.) printer.
•
PC computer with Windows 7, Windows 8.1 or Windows 10 operating system.
•
Graphics software installed in the PC, such as Photoshop, CorelDraw, Photoshop Elements or Illustrator.
•
High Volume Low Pressure (HVLP) electric sprayer or other type of sprayer for applying pretreatment for
dark garments.
•
Use at an altitude of 2000 m or less.
2. UNPACK THE PRINTER
•
Keep shipping box right side up (see arrows)
•
Remove poly wrap and strapping
•
Remove top lid, upper foam and separator sleeve
•
DO NOT LIFT BY PRINT TABLE FRAME, LIFT FROM BOX WITH HELP OF 4 PEOPLE
•
Place printer on your table
•
Unlatch top cover by pressing button below control panel (see diagram) to lift top cover
•
IMPORTANT! Remove BOTH shipping retainer brackets before powering on the printer.
3 thumb screws holding the Table and Print Carriage in position (See diagram below). Keep the brackets
and 3 thumb screws for future use for shipping your printer), you should now be able to move the table
carriage freely back and forth.
3. LEVEL THE PRINTER
•
Locate the six adjustable printer feet under the printer
•
Open top cover. Place a "torpedostyle level" (included) on top of the front metal rail left to right. Adjust left
and right printer feet to level, then adjust middle foot for stability.
17
Remove the