Ricoh SLP26 기술 게시판 - 페이지 20
{카테고리_이름} Ricoh SLP26에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SLP26 46 페이지.
페이지 인쇄
Model:
K-P1, A-C2, J-P1
3) For the customer using a 100Base fixed hub:
Temporary solutions:
Perform both of the following:
a) Set the network (ethernet) speed of the machine to 10Mbps.
The default setting of the machine is "Auto." This setting can be changed in the
"Network Setup" in the user mode "Host Interface" ("Interface Settings" in the
"System Settings" for the Model A-C2).
b) Install a dual speed hub between the 100Base fixed hub and the machine.
End of procedure for the customer using a 100Base fixed hub.
Note:
There is almost no effect on actual print time when the machine's network speed setting
is changed from 100Mbps to 10Mbps.
Permanent Countermeasure:
An interface board (GW-MAC) and a DIMM which contains firmware to drive the board
will be supplied for attachment to the controller board. With these parts, the machine will
work without installing a dual speed hub.
Detailed information on the interface board (GW-MAC) will be announced separately in
mid July.
T
echnical
Network
100Base fixed hub
Originally used by
the customer.
B
ulletin
Date:
10Mbps
100Mbps
Dual speed hub
Install a dual
speed hub
No.:
03-Jul-01
Set the network
speed to 10Mbps
PAGE: 2/3
RG058007