Ricoh SLP26 기술 게시판 - 페이지 43

{카테고리_이름} Ricoh SLP26에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SLP26 46 페이지.

Reissued: 13-Mar-03

Model:

Model K-P1

Firmware Updating Procedure

1. Prepare 2 IC cards with the controller firmware.

2. Turn off the main switch.

3. Remove the IC card slot cover on the rear side of the machine as shown.

4. Insert the IC card-1 and turn on the main switch.

"Onboard Sys. 1/2" is displayed.

5. Press "# Enter."

Note: Make sure that ∗ is displayed.

6. Scroll with the [▲] [▼] key and select "Update."

Press "# Enter" to start downloading.

The "On Line" LED starts blinking and the machine starts to

download the program.

(Notice that the ∗ mark disappears as the program is

downloaded.)

7. When updating card-1 is finished, "Update 1/2 task done" is

displayed.

8. Turn off the main switch and replace the card with IC card-2.

Turn on the main switch, then downloading will automatically

start.

9. When updating card-2 is finished, "Update done" is displayed.

Then, turn off the main switch, remove the card, turn on the

main switch back and print the configuration sheet.

Check that controller firmware is successfully updated.

echnical

ulletin

Date:

12-Apr-01

Onboard Sys. 1/2

∗

Updating

∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗

Update 1/2 task done

Updating

∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗

Update done

PAGE: 5/5

No.:

RG058001e

Update