Ricoh SP C242 Series 펌웨어 업데이트 매뉴얼 - 페이지 12
{카테고리_이름} Ricoh SP C242 Series에 대한 펌웨어 업데이트 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh SP C242 Series 14 페이지.
페이지 인쇄
Message
Machine is not
ready.
Net Upload : End
of data
Net Upload : FAIL
USB Upload : End
of data
USB Upload : FAIL
Wrong Model.
12
Causes
The USB cable is not connected.
The USB printer driver is not
installed in your computer.
The machine is turned off or an
error has occurred.
The IP address specified for
either the machine or your
computer is invalid.
The machine is not connected to
the network properly.
The firmware has been trans-
ferred to the machine success-
fully.
The network cable was discon-
nected immediately after the
[F/W Update (NET)] button was
clicked.
The firmware has been trans-
ferred to the machine success-
fully.
The USB cable was disconnected
immediately after the [F/W Update
(USB)] button was clicked.
The machine you were trying
to update was not the correct
model for the firmware you
have downloaded from our
Web site.
Solutions
Make sure the USB connection be-
tween the machine and computer
is secure.
If this message persists, try an-
other USB cable.
Install the USB printer driver in
your computer.
Turn the machine's power off,
wait a moment, and then turn it
back on again. Then perform the
update again.
If this message reappears after
you turn the power back on, see
the manuals provided with the
machine.
Check that both IP addresses are
valid.
Check that the machine is prop-
erly connected to the network.
Follow the instructions in this
manual to complete the update.
Turn the machine's power off,
wait a moment, and then turn it
back on again. Disconnect any
unnecessary cables from the ma-
chine, and then try again.
Follow the instructions in this
manual to complete the update.
Turn the machine's power off,
wait a moment, and then turn it
back on again. Disconnect any
unnecessary cables from the ma-
chine, and then try again.
The firmware packages on our
Web site are each designed to be
used for a specific model, and can-
not be used for any other model.
Confirm the model of your
machine, and download the ap-
propriate firmware package for
your model.