Ricoh Caplio 500G wide 매뉴얼 - 페이지 5

{카테고리_이름} Ricoh Caplio 500G wide에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Caplio 500G wide 8 페이지.

Manual override

If you want to operate your camera manually, you can do so. Simply rotate Auto/Manual Ring (G) and set the

desired lens opening number at red marker. The instance you rotate Auto/Manual Ring (G) off "A" (Auto), the

letter "M" will appear in the viewfinder indicating your camera is set for manual use.

Lightly hold Shutter Speed Knobs (I) and

rotate Shutter Speed Ring (H) until the desired shutter speed comes

opposite red marker (Fig. 8). The Shutter speed setting governs the

amount of time the film is exposed to light. '60" (1/60 second) is

recommended for subject not in motion. Where motion exists, a shutter

speed ranging from 1/125 to 1/500 should be used.

Look into the viewfinder and you will observe two red zones, one at the upper right-hand corner and the other

lower right-hand corner, and lens opening numbers in between. The upper red zone is warning mark for

overexposure. If the exposure meter needle is in the red warning mark, set Shutter Speed Ring (H) at faster

speed (Fig. 9). If you find the needle in the lower red warning mark, use slower shutter speed (Fig. 10). If the

needle stays on or between numbers, this is correct exposure and the number, such as 2.8 or 4 or 5.6. . .

indicated by the needle tells you the lens opening at which you are going to make exposure.