Ricoh RDC I500 운영 매뉴얼 - 페이지 4

{카테고리_이름} Ricoh RDC I500에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh RDC I500 27 페이지. Ricoh owner's manual digital camera rdc-i500

페이지 인쇄
Ricoh RDC I500 운영 매뉴얼
Problem
Display shut off
Battery is exhausted
Auto power off activated
Remote control
Obstruction between remote control
unit (optional)
unit and camera sensor
will not work
Remote control transmitter or
camera sensor is dirty
Remote control lithium battery is
exhausted
LCD monitor
Area captured by autofocus field
brightness
and surrounding area have different
changes during
light levels or location is dark
autofocus
operation
Vertical lines
Phenomenon occurring with bright
appear on
subject, known as smear
image
phenomenon
Miscellaneous
Problem
Card incorrectly oriented
Card will not go
into slot
Battery exhausted
Camera will not
Camera malfunction
operate in
response to
buttons
Date and time
Date/time setting is incorrect
are wrong
Date and time
Battery removed
were set but
disappeared
Erase menu not displayed
File will not
erase, or card
will not format
File protected
Keep settings mode not enabled
Mode settings
have changed
Auto power off setting is disabled
Auto power off
Camera powered by AC adapter
will not activate.
(auto power off is automatically
disabled when powered by AC
adapter)
Beep will not
Beep disabled
sound
Incorrect video-out signal method.
No image on
Incorrect video I/O switch setting on
TV screen
video equipment
130
Cause
Cause
Remedy
Charge battery.
Switch power on again.
Remove obstruction.
* Remote control reception at front side of
camera.
Clean.
Replace with new lithium battery.
No malfunction.
No malfunction.
Remedy
Insert correctly.
Charge battery.
Switch off power, switch on again and set
mode dial to
(Still Picture) or
If problem persists, reset.
1. Remove battery from camera, switch
power on and reload battery.
2. Try operating again.
Set correct date and time.
Date setting is reset if battery is removed
for approx. 20 days. Set date again.
Set mode dial to
(Play) and press
button.
Cancel protect setting.
Enable keep settings mode.
Enable setting.
–
Set beep sound to [ON].
Select correct video-out signal method.
Check video I/O switch setting on video
equipment.
Page
P.15
P.24
–
–
–
–
–
Page
P.20
P.15
(Text).
–
P.31
P.31
P.103
P.92
P.108
P.110
–
P.111
P.114
–