Ricoh Aficio SP 5200S 초기 매뉴얼 - 페이지 12

{카테고리_이름} Ricoh Aficio SP 5200S에 대한 초기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio SP 5200S 48 페이지. Ricoh initial guide for scanner and fax
Ricoh Aficio SP 5200S에 대해서도 마찬가지입니다: 안전 정보 매뉴얼 (36 페이지), 빠른 매뉴얼 (6 페이지)

페이지 인쇄

1. Using the Scanner Function

The DNS server's IPv4 address or server name

If you are not sure about this information, consult your network administrator.

For details about how to do the above procedures, see the following:

• For procedure (1), see "Configuring the IPv4 Settings".

• For procedure (2), see "Configuring the SMTP Settings".

• For procedure (3), see "Configuring the DNS Settings".

• For procedure (4), see "Configuring the Necessary Settings in [Scanner Features]".

• For procedure (5), see "Creating a Shared Folder on the Computer".

• For procedure (6), see "Registering an e-mail destination in the Address Book", "Registering a

destination computer's shared folder in the Address Book", or "Registering a destination FTP server

folder".

• Depending on security settings, you may have to log in as an administrator to change the network

settings and Address Book. For details, consult your administrator.

• p.10 "Configuring the IPv4 Settings"

• p.12 "Configuring the SMTP Settings"

• p.12 "Configuring the DNS Settings"

• p.13 "Configuring the Necessary Settings in [Scanner Features]"

• p.13 "Creating a Shared Folder on the Computer"

• p.16 "Registering an e-mail destination in the Address Book"

• p.17 "Registering a destination computer's shared folder in the Address Book"

• p.19 "Registering a destination FTP server folder"

Configuring the IPv4 Settings

This section describes how to configure the machine's IPv4 address and gateway address and enable

IPv4.

The procedure for configuring settings differs depending on whether IPv4 address information is

assigned automatically by the network (DHCP) or manually assigned.

Configuring the machine to obtain an IPv4 address automatically

A DHCP server is required on the network for the machine to obtain an IPv4 address automatically.

Press the [User Tools/Counter] key.