Cisco Webex 840 매뉴얼 - 페이지 10

{카테고리_이름} Cisco Webex 840에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Webex 840 12 페이지. Wireless phone
Cisco Webex 840에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (3 페이지), 설정 (10 페이지), 문제 해결 매뉴얼 (6 페이지), 매뉴얼 (36 페이지), 빠른 참조 매뉴얼 (3 페이지), 빠른 참조 매뉴얼 (3 페이지)

Add the Phone to a Nonbroadcast Wi-Fi Network

Before you begin

Get the following information about the Wi-Fi network from your administrator:

• Network name or Service Set Identifier (SSID)

• Network security mode:

• None

• Wi-Fi Protected Access II (WPA2)-Personal: Pre-shared key (PSK)

• WPA2-Enterprise with EAP method:

• PIN or passkey for the security mode, if you use one

Check with your administrator to see if you need any certificates and arrange to install the certificates on your

phone.

Procedure

Step 1

Swipe up from the bottom of the phone's display to show the installed applications.

Step 2

Tap the Settings

Step 3

Select Network & internet > Wi-Fi.

Step 4

Tap Add Network.

Step 5

Enter the desired Wi-Fi Network name.

Step 6

Select the desired Security:

• For an open network, select None.

• For a PSK enabled Wi-Fi network, select WPA2- Personal and enter the 8-63 ASCII or 64 HEX

Password.

• For an EAP enabled Wi-Fi network, select WPA2-Enterprise.

Step 7

For a WPA2-Enterprise network, select the EAP method: PEAP, TLS, or TTLS.

Step 8

For a network with an EAP-TLS security mode, select the desired CA certificate and User certificate.

Step 9

For a network with an EAP-TTLS or PEAP security mode, select the Phase 2 authentication method and

CA certificate option to use, and then enter the Identity and Password.

Step 10

Under Advanced options, set Hidden network to Yes.

You can also set the Proxy and IP settings as required.

Step 11

Tap Save.

Phone Setup

• Protected Extensible Authentication Protocol (PEAP)

• Extensible Authentication Protocol (EAP) Transport Layer Security (EAP-TLS)

• EAP Tunneled Transport Layer Security (EAP-TTLS)

app.

Phone Setup