Cisco Webex 860S 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Webex 860S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Webex 860S 12 페이지.
Cisco Webex 860S에 대해서도 마찬가지입니다: 설정 (10 페이지), 빠른 참조 매뉴얼 (3 페이지), 매뉴얼 (36 페이지), 빠른 참조 매뉴얼 (3 페이지), 빠른 참조 매뉴얼 (3 페이지)

페이지 인쇄

Hot Swap the Battery for Webex Wireless Phone 860 and 860S

Procedure

Step 1

To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.

Caution

Step 2

Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery

compartment.

Step 3

Release the battery clip and grab the battery with your fingers.

Step 4

Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery

compartment.

Warning

Step 5

Gently withdraw the battery tabs from the battery compartment slots and lift the battery out of the battery

compartment.

Warning

Hot Swap the Battery for Webex Wireless Phone 860 and 860S

The Webex Wireless Phone 860 and 860S have a hot swap feature that allows you to continue to use your

phone while you change a low battery. During a hot swap, the internal phone battery provides minimum power

to allow the phone to remain on.

You can perform a battery hot swap under most normal operations, such as during a voice call or other activity

on an active phone screen. Active use of the phone or anything that increases the power draw during a hot

swap may, in rare situations, cause the phone to power off.

Phone Setup

Don't pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry the

clip open. An incorrect prying action with a tool can break the battery clip.

Don't slide the battery across the battery compartment because this action may damage the contacts.

Make sure that no part of the battery drags across the battery contacts in the phone.

Phone Setup