Ricoh Aficio AP400N 보충 설명서 - 페이지 17
{카테고리_이름} Ricoh Aficio AP400N에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio AP400N 38 페이지. Sap printing
Ricoh Aficio AP400N에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 매뉴얼 (12 페이지)
페이지 인쇄
B
Register the printer as a remote printer.
# lpadmin -p np -s nphost!"option" -T dump -I any
• np is the printer name, nphost is the host name. For more information
about "option", see p.20 "Specifying the Device Option".
"lp" will be assigned, if the option is not used.
When printing with the lp command, use ( _ ) instead of ( = ) and ( ; )
instead of ( , ) for operating systems that cannot use ( = ) and ( , ) such as
Solaris 2.5 or later.
C
If your workstation is Solaris 2.5.1, set the print job to active so that it can
be accepted by the print queue.
/usr/lib/accept np
D
If your workstation is Solaris 2.5.1, set the print job to active to print.
/usr/lib/enable np
HP-UX
❖ ❖ ❖ ❖ Adding the IP address and host name to the /etc/hosts file
The following line is added to the /etc/hosts file. The IP address and printer
host name which you previously entered in the installation script will be used.
192.168.15.16 np # Network Printer
• 192.168.15.16 is the IP address, np is the host name, from # to the end of the
line is a comment.
Note
❒ The /etc/hosts file contains a list of the IP addresses and their host names
of all of the hosts communicating on the network. Each entry is delimited
with a space or a tab, and each line is separated with a return.
❒ If you do not use NIS or DNS, you must manually enter the IP address and
host name of each workstation using the network printer in the /etc/hosts
file.
❖ ❖ ❖ ❖ Registering the printer
The installation shell script registers the printer as a remote printer following
the procedure below.
A
Stop the scheduler.
/usr/lib/lpshut
B
Register the printer.
/usr/lib/lpadmin -Pnp -v/dev/null -mrmodel
-ormnphost -orp"option" -ob3
• np is the printer name, nphost is the host name.
For more information about "option", see p.20 "Specifying the Device
Option".
"lp" will be assigned, if the option is not used.
Using the Installation Shell Script
1
13