Ricoh Container Stacker 포장 풀기 및 설정 지침 - 페이지 38

{카테고리_이름} Ricoh Container Stacker에 대한 포장 풀기 및 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Container Stacker 49 페이지.

Adjustment

Adjust paper feed position of Hopper 1

1. Print the same size paper from Hopper 1 and Hopper 2 and check the paper feed-

ing position.

2. If the configuration includes Container Stacker 1, check the paper feeding

position on the sample tray.

3. If the configuration includes Container Stacker 2, open the top cover of Container

Stacker 2, insert the cheater found in the Printer accessory box) in the interlock

switch, and check the paper feeding position on the slit between Paper Guides.

4. Set a standard point in the sample tray and the frame of the Container Stacker and

check the gap of the paper feeding position between Hopper 1 and Hopper 2 and

whether the paper is closer to the front side or the rear side.

a. When the paper from Hopper 1 is closer to the front side compared with the

paper from Hopper 2, there is no need to add a Hopper spacer.

b. If the paper from Hopper 1 is closer to the rear side by 1-2 mm compared with

the paper from Hopper 2, add 1 piece of Hopper spacer at each location as

shown in below.

Container Stacker Installation Instructions 1-33