Ricoh PJ Interactive Kit Type 3 사용 설명서 - 페이지 19

{카테고리_이름} Ricoh PJ Interactive Kit Type 3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh PJ Interactive Kit Type 3 36 페이지.

Hold the cable with the cable clip.

Aligning Pen Recognition Positions

Once pen recognition positions are aligned, you can directly operate the computer display on the

screen.

• Realign pen recognition positions in case of the following:

• After moving the projector

• After changing the input signal resolution

• After changing the display area with a function such as "Zoom" or "Aspect"

• Use one of the computer screen resolutions listed below. If any other resolution is used, the

interactive function may not work normally.

• 1024×768

• 1280×800

• 1366×768

• 1920×1080

Turn on the projector to project the screen.

To turn on the projector or project the screen, see the operating instructions provided with the

projector.

Project the computer screen on the projector screen.

For the projecting procedure, see the operating instructions provided with the projector.

Start the RICOH PJ Interactive Setup Software.

When the images are projected in "Rear" or "Ceiling" mode, select the appropriate

projection mode under "Options" according to how the projector is positioned.

Click [Start Adjustment] under "STEP 1 Adjust Sensor Angle".

Preparations for Using the Interactive Function

Y0E5IX0080