Ricoh PJ WX4241N 사용자를 위한 참고 사항

{카테고리_이름} Ricoh PJ WX4241N에 대한 사용자를 위한 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh PJ WX4241N 2 페이지.
Ricoh PJ WX4241N에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지)

Notes for Users

For PJ X3340/WX3340/X3340N/WX3340N/X3351N/WX3351N/X4240N/WX4240N/X4241N/WX4241N

The following section explains how to clean the air filter on the side of the projector.

The air filter prevents dust and dirt from entering the interior of the projector.

If the message "Check the air filter for dirt." is displayed, check the air filter for dirt or dust, and

use the following procedure to clean off any dirt or dust.

・ Either of the following may occur if the air filter is clogged and the interior of the projector

overheats due to inadequate air circulation. If this is the case, clean the air filter.

"Temperature Error" was displayed, and

the projector turned off during operation.

The lamp turned off during operation.

1. Unplug the power cable from the wall outlet.

2. With the intake vent cover attached to the projector, use a vacuum cleaner over the

cover to remove any dust or dirt collected on the air filter.

Do not use a vacuum cleaner to clean the air filter with the intake vent cover

removed.

If dirt or dust remains on it cleaned with a vacuum cleaner, follow the procedure below to

wash the cover with water.

3. Open the intake vent cover by pushing the tab at

the top of the cover.

4. Remove the intake vent cover from the projector

and wash the cover with water.

After washing the intake vent cover with

water, make sure to dry it completely

before reinstalling it back in the projector.

Do not wash the air filter with water.

Status

Status of LED Indicators

Flashing interval

: 5 seconds

Air filter

Intake

vent cover

DHY725