Ricoh Aficio MP C4000 사용자 설명서 - 페이지 32

{카테고리_이름} Ricoh Aficio MP C4000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Aficio MP C4000 41 페이지. Papercut ricoh embedded manual
Ricoh Aficio MP C4000에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 기능 설명서 (27 페이지)

페이지 인쇄

PaperCut – Ricoh Embedded Manual

7 FAQ & Troubleshooting

The "Extended Feature Settings" button does not appear in the admin settings.

This may indicate that you do not have the Ricoh Java Card installed correctly. Check that

the Java SD card is inserted into Slot 3 of the Ricoh device. If you have problems enabling

the Java Card, please contact your hardware vendor for assistance.

What is the IP address of my PaperCut Server?

Use operating system command-line tools such as ipconfig or ifconfig to determine this.

The embedded application shows "Connecting to server '<servername/ip>'?

This indicates that the embedded application is unable to connect to the PaperCut server

over the network. The embedded application will continually try to connect to the server

(trying both the server name and IP), so if there is a temporary network outage then it will

start working once the connection is available again.

Common causes of this problem are:



The PaperCut application server is not running.



There are firewalls or network routing configuration that is stopping the network

connection being established. Check that for firewalls on the PaperCut server or with

your network administrator.



There is a network outage that is stopping the connection being established. Try

accessing the web interface on the Ricoh to check that a network connection can be

established.



The PaperCut server name or IP was set incorrectly in "connection.properties".

NOTE: To change the connection settings you will need to reinstall the

embedded application after updating the "connection.properties" file.

The PaperCut embedded application is not listed in the applications to install?

This can happen if the embedded application is not copied to the Java SD card in the correct

location/format. Check that files were copied to the card as described in the setup

instructions.

I see an error on the Ricoh LCD screen?

This may indicate a configuration issue, or maybe a software bug. Re-check your settings

and restart the MFD (i.e. power-off and power-on the copier). If problems continue, contact

PaperCut Support.

Revision: 19

2012-10-26

32 of 41