Epson EMP 30 - PowerLite 50c XGA LCD Projector 빠른 설정
{카테고리_이름} Epson EMP 30 - PowerLite 50c XGA LCD Projector에 대한 빠른 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP 30 - PowerLite 50c XGA LCD Projector 2 페이지. Epson powerlite 70c: quick start
Epson EMP 30 - PowerLite 50c XGA LCD Projector에 대해서도 마찬가지입니다: 사양 (2 페이지), 제품 정보 (13 페이지)
페이지 인쇄
Locate everything
you'll need
For most setups, you'll need just these two cables:
power cord
You won't need to install any software.
Connect the projector
to your laptop
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer cable to the
Computer port on the projector.
3
Connect the other end to your laptop's video or
Plug in your projector
Connect the power cord to your projector and plug the other end into a grounded outlet.
Turn on your equipment
1
Turn on the projector first. To do so, press the red Power button.
The
power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
2
Turn on or restart your laptop. (Windows
New Hardware Wizard screen, click Cancel.)
computer cable
monitor port.
®
only: If you see a
Caution: Before unplugging the projector...
Press the red Power button twice, then let the projector cool while the
flashes orange (about a minute). Once the light stops flashing and stays on, it's safe to
unplug the projector.
Never unplug the projector when the
EPSON
®
PowerLite
Quick Setup
Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User's Guide.
Power
Help
?
power light is green or flashing orange.
®
50c/70c
power button
power light
power light
Turn Over