Cisco 10008 빠른 시작 매뉴얼 - 페이지 19

{카테고리_이름} Cisco 10008에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 10008 49 페이지. Cisco systems router quick start guide

Connecting Power

Use this section for information about connecting power to the Cisco 10008 router.

• If you are connecting DC power to the system, go to the

page

19.

• If you are connecting AC power to the system, go to the

page 23

This section describes how to connect the Cisco 10008 router to a –48 VDC power source. The power connectors are pillar

terminals on the backplane. For full power redundancy, each set of DC power connectors (terminal blocks labeled A and B) must

be connected to separate power sources. If you do not require power redundancy, you can use only one set of terminals—either

the A terminal block or the B terminal block. Do not use one of each.

Warning

Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49

Warning

Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and

watches). Metal objects will heat up when connected to power and ground and the heat can cause serious burns

or weld the metal object to the terminals. Statement 43

Warning

This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation.

Install only in accordance with national and local wiring regulations. Statement 1045

"Connecting DC Power to the Cisco 10008 Router" section on

"Connecting AC Power to the Cisco 10008 Router" section on