Cisco 10008 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 10008에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 10008 49 페이지. Cisco systems router quick start guide

Preparing for Installation

This section guides you through the process of preparing for your router installation.

Warning

Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49

Before you install the Cisco 10008 router, consider:

• The power and cabling requirements that must be in place at your installation site

• The equipment required to install the router

• The environmental conditions your installation site must meet to maintain normal operation

Do not unpack the system until you are ready to install it. Keep the chassis in the shipping container to prevent accidental

damage until you determine an installation site. Use the appropriate unpacking documentation included with the system.

Table 2

lists the tools, equipment, and supplies necessary to install the Cisco 10008 chassis in the rack and connect the system

ground to the chassis.

Table 2

Tools and Supplies

Quantity

Description

Number 2 Phillips screwdriver

3/16-inch flat-blade screwdriver

1/4-inch flat-blade screwdriver

Antistatic mat or antistatic foam

Electrostatic discharge (ESD) grounding strap or the disposable ESD

strap shipped with the system

Wire-stripping tool

Crimping tool

2-hole grounding lugs

Varies

Grounding wire

M5 power entry module (PEM) screws with captive, locking washers Included in accessory kit shipped with

Varies

Screws to attach ground wire to grounding point at site

Comments

—

Must fit diameter of grounding lugs.

Must fit No. 6 stranded, No. 6 weld, or

37/24 flex cables. Each lug has two holes,

centered 0.625 in. (1.587 cm) apart and

accepts M5 screws.

6 AWG, 0.204 in. (5.18 mm) recommended.

Cisco 10008 router.

Part requirements depend on location.