Cisco 1100 Series 설치 및 업그레이드 - 페이지 6

{카테고리_이름} Cisco 1100 Series에 대한 설치 및 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1100 Series 15 페이지. Terminal gateway
Cisco 1100 Series에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 하드웨어 설치 매뉴얼 (44 페이지)

페이지 인쇄
Cisco 1100 Series 설치 및 업그레이드

AC Power Supplies

AC Power Supplies
Overview of the AC Power Supply
Power supply of the Cisco 1100 Series ISRs is an external AC to DC power adapter. The external power
adapter DC power connector plugs in to the router 4-pin power connector, to power the unit.
Figure 4: Power Supply Unit
1

Installing and Removing SFP Modules

This section describes how to install optional small-form-factor pluggable (SFP) modules in the router to
provide optical Gigabit Ethernet connectivity.
The SFP module installs into a slot on the router rear panel. When selected in Cisco IOS software, it is assigned
port gigabitethernet 0/0/0. The default is the built-in RJ-45 1000Base-T connector, which is enabled on this
port.
Only SFP modules certified by Cisco are supported on the routers.
Table 1: SFPs Supported on the Router
Cisco Model
Number
GLC-EX-SMD
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
6
Minimum
Description
IOS-XE Version
3.15
1000BASE-EX
SFP transceiver
module, SMF,
1310nm, DOM
Installing and Upgrading Internal Modules and FRUs
Power Cable