Cisco 1100 Series 하드웨어 설치 매뉴얼 - 페이지 27

{카테고리_이름} Cisco 1100 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1100 Series 44 페이지. Terminal gateway
Cisco 1100 Series에 대해서도 마찬가지입니다: 설치 및 업그레이드 (15 페이지), 매뉴얼 (12 페이지)

페이지 인쇄

Install and Connect the Router

Chassis Grounding

Warning

To reduce the risk of electric shock, the chassis of this equipment needs to be connected to permanent earth

ground during normal use. Statement 445

Warning

Only skilled person should be allowed to install, replace, or service this equipment. Refer to statement 1089

for description of skilled person. Statement 1090

After you set up the router, connect the chassis to a reliable earth ground; the ground wire must be installed

in accordance with local electrical safety standards. For safety information on grounding the chassis, refer to

the chassis ground connection procedures.

1. For grounding the chassis, use a copper wire of size of 6 AWG and the ground lug.

2. Use the M4 screws, which have a length of about 8 mm.

To install the ground connection for your router, perform these steps:

1. Strip one end of the ground wire to the length required for the ground lug orterminal. (For the ground

lug—approximately 0.75 inch (20mm)).

2. Crimp the ground wire to the ground lug, using a crimp tool of the appropriatesize.

3. Attach the ground lug to the chassis as shown in the below figures. The screw for the ground lug is

provided. Tighten the screw; the recommended torque is 8 to 10 inch-lbf (0.9 to 1.1N-m)

Hardware Installation Guide for the Cisco 1100 Terminal Gateway

Chassis Grounding