Cisco 12000 - Series Chassis Modular Expansion Base 교체 지침 매뉴얼 - 페이지 25
{카테고리_이름} Cisco 12000 - Series Chassis Modular Expansion Base에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 12000 - Series Chassis Modular Expansion Base 40 페이지. Internet router line card failures
Cisco 12000 - Series Chassis Modular Expansion Base에 대해서도 마찬가지입니다: 데이터시트 (9 페이지), 개요 매뉴얼 (6 페이지), 하드웨어 문제 해결 매뉴얼 (18 페이지)
페이지 인쇄
Figure 10
For the DIMM you want to remove, use the socket release levers to eject the DIMM.
Step 4
•
•
Caution
Handle the edges of the DIMM only. (See
DIMM, the metal traces, or fingers, along the edge of the DIMM, or the pins in the DIMM socket.
As one end of the DIMM is released, grasp the top corners of the DIMM with the thumb and forefinger
Step 5
of each hand and pull the DIMM completely out of its socket.
Immediately place the DIMM in an antistatic bag to protect it from ESD damage.
Step 6
Repeat
Step 7
Installing a DIMM in a Line Card
Note
If you are upgrading packet memory, both DIMM sockets of a given pair (either the transmit buffer or
the receive buffer) must be populated with an SDRAM DIMM of the same type and size.
ISE, Engine 4, and Engine 4+ line card packet memory is not field serviceable. Only qualified Cisco
Caution
personnel should service these memory modules. See the
To install new DRAM or SDRAM DIMMs in a Cisco 12000 Series Router line card, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and connect the leash to one of the ESD connection
Step 1
sockets on the front of the chassis or to a bare metal surface on the chassis.
Place the line card on an antistatic mat so that the faceplate is nearest to you.
Step 2
To prevent router and memory problems, all DIMMs installed in the line card must be 3.3-volt devices.
Caution
78-4338-16
DIMM Socket with Dual Release Levers
For a socket with a single release lever (see
DIMM.
For a socket with dual release levers (see
eject the DIMM.
Step 4
through
Step 6
for any remaining DIMMs that you want to remove.
Removing and Installing Line Card Memory
Figure
7), pull down that release lever to eject the
Figure
10), pull down on both levers at the same time to
Figure
8.) Do not touch the integrated circuit devices on the
"Installing a SODIMM" section on page 29
Cisco 12000 Series Router Memory Replacement Instructions
25