Cisco 12000/10/16-BLWER= 교체 지침 매뉴얼 - 페이지 4

{카테고리_이름} Cisco 12000/10/16-BLWER=에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 12000/10/16-BLWER= 18 페이지. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router

페이지 인쇄

Installation Guidelines

The blower modules support online insertion and removal (OIR), so you can remove and install a blower

module while the system remains powered on without presenting an electrical hazard or damage to the

system. You can replace a blower module while the system maintains all routing information and ensures

session preservation.

Although the blower module supports OIR and can be replaced without interruption to system operation,

Caution

the system should not operate without a blower module for more than 3 minutes to prevent overheating.

Caution

You cannot mix blower types within the chassis. If you are replacing a blower module from an old system

(GSR16-BLOWER=) , you must replace both upper and lower blower modules with new, higher capacity

replacement blowers (12000/10/16-BLWER=). Although the blower modules can be replaced without

interruption to system operation, the system should not operate with mixed blower modules in the router

for more than 5 minutes.

Required Tools and Equipment

You need the following tools and equipment to install the blower module:

•

Removing and Replacing the Blower Modules

This section contains the procedure to remove and replace the upper or lower blower modules from the

chassis. Before beginning either of these procedures, be sure to read the

on page

Upper and Lower Blower Module Orientation

Illustrations in this procedure show the removal and replacement of the upper blower module. The

procedure to replace the lower blower module is the same except for the orientation of the blower

module.

•

Cisco 12016, Cisco 12416, and Cisco 12816 Router Blower Module and Air Filter Replacement Instructions

Number 2 Phillips screwdriver

3/16-inch flat-blade screwdriver

An electrostatic discharge (ESD) preventive wrist or ankle strap with connection cord

Vacuum cleaner (to clean the air filters)

Heads-up orientation—Install the blower module in the upper bay in the "heads-up" orientation with

the three fan air intake openings face down.

Heads-down orientation—Install the blower module in the lower blower module bay in the

"heads-down" orientation with the three fan air intake openings face up.

"Installation Guidelines" section

78-16083-02