Cisco 12004 GSR 참고 자료 - 페이지 6

{카테고리_이름} Cisco 12004 GSR에 대한 참고 자료을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 12004 GSR 17 페이지.

20614 Cisco Installing and Maintaining Routers Part 4: 12000 GSR Series and XS5032 Modules

System Startup

Turn each system power switch to the ON position.

Check that the blower modules are operating by listening for them.

As the GRP boots, observe the GRP alphanumeric LED displays.

As the line cards boot, observe the alphanumeric LED indicators on each line card. Line cards boot from

left to right.

Boot the Cisco IOS software image you want to use by entering the appropriate b command at the ROM

monitor prompt (>).

Proceed with the setup facility or exit from setup and use configuration commands to configure global and

interface−specific parameters.

Cisco 12008 GSR: Installation

Upper Card Cage: Removing Cards

Attach an antistatic ESD wrist strap to your wrist.

Insert the banana jack into the ESD connection socket.

Write down each card type and card location.

Loosen the captive screws.

Pivot the two card ejector levers away from the faceplate to unseat the card.

Slide the card out of its slot.

Stack the removed card on an antistatic mat for ESD protection.

Power Supply: Removing

Set the power to the off position.

Turn the captive screw on the power supply faceplate.

Pull the power supply unit halfway out of its bay.

Pull the power supply unit out completely.

Set the power supply unit aside in a safe place.

Catalyst 3000 and 5000 Router Modules

Catalyst 3000 Router: Installation