Epson EMP 7900 네트워크 매뉴얼 - 페이지 38
{카테고리_이름} Epson EMP 7900에 대한 네트워크 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP 7900 43 페이지. Esc/vp21 command user's guide for business projectors
Epson EMP 7900에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용자 설명서 (25 페이지), 사양 (4 페이지), 사용자 설명서 (25 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (28 페이지)
페이지 인쇄
The message "Could not complete communicating configuration data"
appears when you send settings to the network interface.
Cause
This may happen when using a
dial-up router.
Unable to start EpsonNet Config with Web Browser.
Cause
You have not set the IP
address for the network
interface.
The Model Name and IP Address do not appear in the EpsonNet Config dialog
box.
Cause
If a valid IP address is not set,
the items indicated in the
dialog box mentioned above
may not appear.
38
Troubleshooting
What to do
Run Command Prompt from the computer on
which EpsonNet Config is installed, and then
enter the following command:
Format: >ROUTE_ADD_the IP address of the
network interface_ the IP address of the
computer (the under bar represents one space)
Example: >ROUTE ADD 192.168.192.168
22.33.44.55.
What to do
Set the IP address for the network interface using
EpsonNet Config or the printer's control panel.
You can check the IP address by printing a
network status sheet, see "Printing a Network
Status Sheet" on page 18.
What to do
Set a valid IP address.
Refresh the status by selecting Refresh from the
View menu.
Increase the length of time before a timeout. To
do this, select Options from the Tool menu, and
then select Timeout. Note that doing so can
cause EpsonNet Config to slowly.