Cisco 1600 series 하드웨어 설치 매뉴얼 - 페이지 14
{카테고리_이름} Cisco 1600 series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1600 series 14 페이지. Rdiag router analog ipsec
Cisco 1600 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 설치 또는 교체 (10 페이지)
페이지 인쇄
GHVFULSWLRQ
6WHS
Enter into the enable modus of
the router
6WHS
Enter the password to get into
the enable modus (this entry is
not visible)
6WHS Enter into the configuration
modus of the router
The following output will appear Enter configuration
6WHS set the ip for modem1
6WHS Enter ctrl-z
The following output will appear 3d22h: %SYS-5-CONFIG_I:
6WHS log onto the modem
The following output will appear Trying modem1
6WHS Enter the username
6WHS Enter the password (not visible) password
The following output will appear Password OK
6WHS Echo on
The following output will appear OK
6WHS Reset to factory settings.
1RWH: 0 is „zero"
The following output will appear OK
6WHS Press ctrl-shift-6
6WHS
6WHS Disconnect from the modem
6WHS Confirm that the connection to
modem1 shall be closed
6WHS
Now your modem and your router are ready to be remotely configured by SIEMENS Remote Services.
$SSHQGL[ . ,6'1 XVH RI WKH DQDORJ URXWHU
1RWH Should it become necessary to switch from the analog connection to an ISDN connection, the
configuration can be done via the analog port of the router.
Siemens Remote Service
Installation instruction
5RXWHU SURPSW
jac0356323qc828>
password:
jac0356323qc828#
commands, one per line.
End with CNTL/Z.
jac0356323qc828(config)#
jac0356323qc828(config)#
Configured from console
by console
jac0356323qc828#
(10.6.254.2, 2001)...
Open
User Access Verification
username
jac0356323qc828#
Closing connection to
modem1 [confirm]
COIT-000.812.04.02.02
Rev. 02
02-02
FRPPDQG
HQDEOH
SUHVHF
FRQILJXUH WHUPLQDO
LS KRVW PRGHP
A]
PRGHP
SUHUGLDJ
SUHVHW
DWH
DW I Z
A>VKLIW@
[
GLVFRQQHFW
FU!
H[LW
Seite 14/14
CO SGK
Medical Solutions
Siemens AG