Cisco 1712 - Security Access Router 하드웨어 설치 매뉴얼 - 페이지 10
{카테고리_이름} Cisco 1712 - Security Access Router에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1712 - Security Access Router 21 페이지. Security access routers
Cisco 1712 - Security Access Router에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 데이터시트 (8 페이지)
페이지 인쇄
Verifying Your Installation
Verifying Your Installation
Optional Installation Steps
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-10
You can verify that you have correctly installed the router by checking the
following LEDs:
PWR (front panel)—On when power is being supplied to the router.
•
OK (front panel)—On when the router software is loaded and functional.
•
Blinking means that the router is performing a power-on self-test (POST).
WIC0/WIC1 OK (back panel)—On when a WIC is correctly installed in the
•
corresponding WIC slot.
ETH ACT (front panel)—Blinking when there is network traffic on the local
•
10/100 Ethernet LAN.
WIC0ACT or WIC1 ACT (front panel)—See
•
LINK (back panel)—On when the router is correctly connected to the local
•
Ethernet LAN through the 10/100 ETHERNET port.
MOD OK (back panel)—On when the VPN hardware encryption module is
•
installed and recognized by IOS.
This section describes some installation steps that you might or might not use,
depending on your site and on how you are configuring the router. This section
describes the following procedures:
Connecting a PC to the Router's Console Port
•
•
Connecting a Modem on the AUX Port
Wall-Mounting
•
Stacking the Router
•
Unstacking the Router
•
Chapter 2
Installation
Table
1-3.
OL-4050-02