Cisco 1720 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Cisco 1720에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1720 13 페이지. Cabling and installation
Cisco 1720에 대해서도 마찬가지입니다: 데이터시트 (12 페이지), 빠른 시작 매뉴얼 (13 페이지)
페이지 인쇄
Install the WAN Interface Card(s)
Look for a WAN interface card in one or both of the two slots on the rear of the router. If a card is already installed, connect
it to the WAN line according to the <Emphasis>Cisco WAN Interface Cards Hardware Installation Guide that came with the
card. To install a card in either slot, follow these instructions:
Step 1
Set the power switch to the STANDBY (
Step 2
Remove the screws that hold the slot cover in place, and then remove the slot cover.
Figure 2
Locating the WAN Interface Card
C is c o
1 7 2 0
W IC
CO NS
0 O K
O LE
FD X
10 0
LN K
10 /1 00
ET HE
RN ET
AU X
WAN interface card slot cover
Step 3
Hold the card by the edges and line it up with the guide on the card slot.
Step 4
Push the card into the slot until it is seated in the connector and the front panel is flush with the router rear panel.
Figure 3
Installing the WAN Interface Card
C is c o
1 7 2 0
CO NS
W IC
0 O K
O LE
FD X
10 0
LN K
10 /1 00
ET HE
RN ET
AU X
SE E
MA NU
AL BE
FO RE
INS TA
LLA TIO
DS U
N
56 K
WAN interface
Guides
card slot cover
Step 5
Tighten the screws that are in the card.
Step 6
Connect the card port to the WAN line according to the <Emphasis>Cisco WAN Interface Cards Hardware Installation
Guide.
W IC
1O K
W IC
1O K
) position and confirm the router is not connected to the power supply.
5