Cisco 1720 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Cisco 1720에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1720 13 페이지. Cabling and installation
Cisco 1720에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 데이터시트 (12 페이지)
페이지 인쇄
Connect a PC to the Router
To use Cisco IOS software to configure the router, it must be connected to a terminal or to a PC with terminal-emulation
software. Terminal emulation software should be configured with the following settings: 9600 baud, 8 data bits, no parity bits,
and 1 stop bit. The Cisco 1700 Router Software Configuration Guide describes how to configure the router using Cisco IOS
software.
Take the following steps to connect the router to one of these devices:
Step 1
Connect one end of the blue console cable (included) to the CONSOLE port on the router rear panel.
Step 2
Connect the RJ-45 end of the gray DB-9-to-RJ-45 adapter (included) to the unconnected end of the console cable.
Figure 4
Connecting a PC to the Router
C i s c o
1 7 2 0
W IC
0 O K
F D X
1 0 /1 0
0 E T
Console cable
Connect the DB-9 end of the adapter to the console port (also called the serial port) on your PC. If this adapter does
Step 3
not fit your PC console port, you must provide an adapter that fits.
6
C O N
S O L
E
SE E
L N K
M AN
UA L
H E R
BE FO
RE IN
N E T
ST AL
D SU
LA TI
ON
56 K
A U X
W IC
1 O K
Console port
To PC or terminal