Cisco 1721 - VPN Security Router Bundle 빠른 시작 매뉴얼 - 페이지 8
{카테고리_이름} Cisco 1721 - VPN Security Router Bundle에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1721 - VPN Security Router Bundle 17 페이지. Troubleshooting guide
Cisco 1721 - VPN Security Router Bundle에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (11 페이지), 데이터시트 (12 페이지), 사용자 설명서 (48 페이지), 하드웨어 문제 해결 (12 페이지)
페이지 인쇄
8
Verify Your Installation
You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.
Table 1
LEDs That Verify Installation
LED
PWR
OK
LINK
FDX
100
ETH ACT
WIC0 ACT and WIC1 ACT
WIC0 OK and WIC1 OK
MOD OK
9
Configure the Router Using Cisco Router and Security Device Manager
Cisco Router and Security Device Manager (SDM) is a web-based configuration tool that allows you to configure LAN
and WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router.
If SDM is installed on your router, configure the router by following the instructions in the Cisco Router and Security
Device Manager (SDM) Quick Start Guide. If this document was not shipped with your router, you can obtain SDM and
instructions for installing it on your router from the following location:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
To obtain the SDM release notes, and other SDM documentation, go to http://www.cisco.com/go/sdm and click the Technical
Documentation link.
8
Panel
What to Look For
Front
On when power is being supplied to the router.
Front
On when the router software is loaded and
functional.
Blinking when the router is running a power-on
self-test (POST). Continual blinking can indicate a
problem with the router, although the LED will
also blink if the router is in ROMMON mode.
Refer to the "Troubleshooting" chapter in the
Cisco 1721 Router Hardware Installation Guide
for more information.
Back
On when the router is correctly connected to the
Ethernet network through the 10/100
ETHERNET port.
Back
On when the Ethernet port is operating in
full-duplex mode.
Back
On when the 10/100 ETHERNET port is
operating at 100 Mbps.
Front
Blinking when there is network traffic on the local
Ethernet LAN.
Front
On solid or blinking when there is data traffic on
the corresponding WIC port. Refer to Table 1-4 in
Chapter 1, "Cisco 1721 Router Overview," of the
Cisco 1721 Router Hardware Installation Guide,
for detailed information.
Back
On when a WIC is correctly installed in the
corresponding WIC slot.
Back
On when the VPN hardware encryption module is
installed and recognized by the IOS.