Cisco 1760 - VPN Bundle Router 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 1760 - VPN Bundle Router에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1760 - VPN Bundle Router 40 페이지. Non-proprietary security policy
Cisco 1760 - VPN Bundle Router에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지)

페이지 인쇄

Cisco 1760 - VPN Bundle Router 빠른 시작 매뉴얼

Do not connect a WAN, telephone or fax cable to the card until you have completed the installation procedure.

Caution

Card Installation

Follow these steps to insert a card in the router:

Make sure the router is turned off and is disconnected from AC power.

Step 1

Power must be removed from the system prior to installing or removing WICs or VICs to avoid damaging them.

Caution

When WICs or VICs are pushed into or pulled out of a router that is powered up, there is a very good chance that

they could be damaged electrically and will no longer function.

Loosen the thumbscrews on the WIC or VIC slot cover, as shown in Figure 5.

Step 2

Figure 5

Removing a WIC or VIC Slot Cover

PW R

PVD M 0

PVD M 1

MO D

SLO T 0

SLO T 1

ACT

COL

FDX

100

You should be able to loosen the screws using your fingers; however, if the screws are very tight, you may need to use a Phillips

screwdriver.

Remove the metal plate that covers the card slot.

Step 3

Hold the card by the edges on either side of the card front panel, and line up the card edges with the guides inside the

Step 4

card slot, as shown in Figure 6.

Figure 6

Inserting a WIC or VIC in the Router

PW R

PVD M 0

PVD M 1

MO D

SLO T 0

SLO T 1

Interface Card

Insert the card in the slot, and gently push it into the router until the front panel of the card is flush with the router.

Step 5

CON SOL

LINK

10/1 00 ETH

ERN ET

AUX

SLO T 2

SLO T 3