ActronAir SWB36C/E 사용자 설명서 - 페이지 6
{카테고리_이름} ActronAir SWB36C/E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ActronAir SWB36C/E 8 페이지. Air conditioner
페이지 인쇄Dehumidifying operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor un it st arts flashing.
1. Press the
2. Press the
desired temperature.
ca n be set with in a range of 17 C~ 30 C
3. Press the
co nditione r.
NOTE
O N / O F F
In the Dehumidifying mode, you can not switch the
3
fan speed. It has already been automatically controlled.
2
MODE
SHORTCUT
1
FAN
SWING
TEMP
SP EED
Adjusting air flow direction
TIMER
TIMER
DI RECT
OFF
ON
Use the SWING and DIRECT buttons to adjust
the desired airflow direction.
TU RBO
LED
SLEEP
SEL FC LEA N
FOLLOW ME
1. When press the DIRECT button, the horizontal
louvre changes 6º degree in angle for each press.
RES ET
LOCK
2. When press the SWING button, the louvre will
automatically swing up and down.
NOTE:
MODE
button to select DRY m ode .
UP/DOWN
buttons to set the
The temperature
O
in 1 C inc rements.
O
ON/OFF
but ton to start th e air
When the horizontal louvre swing or move
to a position which would affect the cooling
or heating effect of the air conditioner, it
would automatically change the swing /
moving direction.
O
O N / O F F
MODE
TEMP
SWI NG
TIMER
DIRECT
ON
TURBO
SLEEP
SELF CLEAN
RES ET
Timer operation
Press the TIMER ON button can set the auto-on
time of the unit. Press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
1
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
24 hours.
FAN
SPEED
3. After setting the TIMER ON ,there will be a one
second delay before the remote controller
TIMER
OFF
2
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
LED
FOLLOW ME
signal "H" will disappear and the set temperature
will re-appear and the TIMER ON will appear on the
LOC K
LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-off time to stop the operation.
2. Push the TIMER OFF button again to set
desired Auto-off time. Each time you press the
button, the time increases by half an hour
between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER OFF ,there will be a
one second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "H" will disappear and the set temperature
will re-appear and the TIMER ON will appear on the
LCD display window.