Cisco 1941 설치 및 업그레이드 - 페이지 12
{카테고리_이름} Cisco 1941에 대한 설치 및 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1941 24 페이지. 1900 series
페이지 인쇄Modules Internal to the Cisco 1941 Router
Installing an ISM
Before you install an ISM, remove the chassis cover as described in the
Chassis" section on page
To install an ISM, perform the following procedure. To complete this procedure, you need a number 2
Phillips screwdriver or flat-blade screwdriver, and a 1/4-inch nut driver or wrench.
Installing an ISM in a Cisco 1900 Series Router
The Cisco 1900 series routers have one ISM connector on the system board. To install the ISM, perform
the following steps. The ISM is an optional upgrade. The procedure below assumes you are upgrading
your router to include an ISM.
Step 1
Find the location of the four screws on the system board near the ISM connector. When no ISM is
installed the four screws are holding the system board in place. See
page
Figure 8
1
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
12
5.
7.
System Board ISM Screws
ISM screw
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
1
"Opening and Closing the
"Locating Modules" section on
1