Cisco 2500 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Cisco 2500 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2500 Series 12 페이지. Wireless controller
Cisco 2500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (19 페이지), 배포 매뉴얼 (23 페이지), 구성 매뉴얼 (50 페이지), 시작하기 매뉴얼 (47 페이지)

페이지 인쇄
Cisco 2500 Series 설치 매뉴얼
Figure 9
DC Power Supply Connections
Ground
Terminal block
Warning
When stranded wiring is required, use approved wiring terminations, such as closed-loop or spade-type
with upturned lugs. These terminations should be the appropriate size for the wires and should clamp both the
insulation and conductor. (To see translated versions of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied your router.)
Do not overtorque the terminal block captive thumbscrew or terminal block contact screws. The
Caution
recommended torque is 8.2 0.4 inch-lb .
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate
power by moving the handle of the circuit breaker to the ON position. (To see translated versions of this warning,
refer to the Regulatory Compliance and Safety Information document that accompanied your router.
Negative
Terminal block
Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers
Connecting the DC Power Supply
Positive
On/off
9