Cisco 2504 시작하기 매뉴얼 - 페이지 5

{카테고리_이름} Cisco 2504에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2504 47 페이지. Wireless controller
Cisco 2504에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄
Cisco 2504 시작하기 매뉴얼
Callout
Port and LEDs
2
GigE port and LED
3 & 4 POE
GigE Power-over-Ethernet
(POE) ports
RESET
Reset button
PWR
Power LED
SYS
System LED
State and Description
The Gigabit Ethernet port is an RJ-45 connector
form-factor. This port is designed so that 1500 VAC rms
isolation (per the 802.3 specification) is met between
chassis ground and any 48V/Ethernet signal.
LED description:
Green or Blinking Green—Link activity
•
Off—No link
•
The Gigabit POE ports are RJ-45 connector form-factor.
They provide a I2C communications channel between
the PSE controller and host CPU TWSI bus #1. This
interface supports the proper voltage isolation as defined
by 802.3. The POE controller is configured to I2C
address 0x40/41 (0100 000r/w).
The POE controller reset is driven from system reset. If
software needs to reset the POE controller, it can do so
over I2C.
LED description:
Green or Blinking Green—Link activity
•
Off—No link
•
The ports can be used for infra-switch connection
Note
using multiple an AP-Manager or data interface.
Pushing the Reset button reboots the system.
The power LED light is on when all the power conversion
circuits are running normally.
LED description:
Green—Power is on
•
Off—No power to the system
•
The system LED determines if the system is powered up.
LED description:
Blinking Amber—Boot-loader is active and waiting
•
for user input from the system console.
Blinking Green—Boot-loader or booting.
•
Green—Normal System Operation.
•
Amber—System failed the bootup process or an
•
error caused the system to halt. A status or error
message is posted on the console screen.
•
Off—System not receiving power.
Cisco 2500 Series Wireless Controller Getting Started Guide
About This Guide
5