Epson EMP-73 빠른 참조 매뉴얼 - 페이지 3

{카테고리_이름} Epson EMP-73에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EMP-73 5 페이지. Emp-73
Epson EMP-73에 대해서도 마찬가지입니다: 브로셔 및 사양 (24 페이지), 첫 번째 매뉴얼 읽기 (33 페이지), 사양 (1 페이지), 사용자 설명서 (25 페이지), 사용자 설명서 (25 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (28 페이지), 사양 (2 페이지)

페이지 인쇄
Epson EMP-73 빠른 참조 매뉴얼
Adjustments

Adjusting the image angle

While pressing the foot adjust buttons at either side, lift up the
front of the projector.
When the desired angle is obtained, release the foot adjust
buttons.
Front adjustable feet
When the projector is tilted, it will cause keystone distortion to
appear in the image, but this distortion can be corrected using the
automatic keystone correction function as long as the vertical
angle of tilt is within a range of approximately 15˚. If you would like
to make further minor adjustments to the effects of automatic
keystone correction, use [keystone] on the projector's control
panel.
The following adjustments can also be made.
Automatic setup (only when computer images are projected)
Tip
User's Guide "Adjusting Computer Images"
When projecting computer images, the input signals are detected automatically and
adjusted so that the optimum images are projected. If the results of automatic adjustment
are not satisfactory, individual settings can also be adjusted manually using the menus.
Other adjustments
Press [Menu] on the remote control to display the configuration menu. You can use the
configuration menu functions to adjust setting such as brightness, contrast and colour.

Turning Off the Projector

1
Turn off the power for all sources connected to
the projector.
Press
twice to turn off the power.
2
The Power indicator will flash orange (cool-down in
progress/about 20 seconds).
Check that the Power indicator lights orange,
3
and then disconnect the power cable from the
electrical outlet.
Foot adjust button
User's Guide "Using the Configuration Menu Functions"
User's Guide
"Adjusting the Screen Image"
Adjusting the image
size and focus
Fine adjustments to
image size
Turn the zoom ring to adjust the
image size.
Turn to the "W" side to increase
the image size, and turn to the "T"
size to reduce the image size.
Adjusting the focus
Turn the focus ring to adjust the
focus.
User's Guide
"Turning Off the Projector"
Power indicator
Operating problems
may occur if the power
cable is disconnected
while the Power
indicator is flashing
orange.