Cisco 2600 Series 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 2600 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2600 Series 5 페이지. Configuring adsl wic to support pppoe clients
Cisco 2600 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 릴리스 정보 (32 페이지), 구성 (15 페이지), 애플리케이션 노트 (41 페이지), 데이터시트 (6 페이지), 부록 (15 페이지), 설치 매뉴얼 (22 페이지), 개요 (13 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Cisco 2600 Series 매뉴얼
Configurations
This document uses the configurations shown below.
Note: In the Cisco 6400 NRP configuration, you set the Maximum Transmission Unit (MTU). For more
information about changing the MTU size, refer to Troubleshooting MTU Size in PPPoE Dialin Connectivity.
Current configuration:
!
version 12.1
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password−encryption
!
hostname R1
!
ip subnet−zero
no ip routing
!
interface FastEthernet0
no ip address
no ip directed−broadcast
bridge−group 1
!
interface ATM0
no ip address
no ip directed−broadcast
no ip mroute−cache
no atm ilmi−keepalive
pvc 3/100
encapsulation aal5snap
!
bundle−enable
bridge−group 1
hold−queue 224 in
!
ip classless
no ip http server
!
bridge 1 protocol ieee
!
line con 0
end
Current configuration:
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
no service password−encryption
!
hostname NRP1
!
username username password password
!−−− The username and password must match client username and password.
Cisco ADSL WIC
Cisco 6400 NRP