ActronAir LC7-2G 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} ActronAir LC7-2G에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActronAir LC7-2G 8 페이지. Wall control

페이지 인쇄

Installation Guide

03. Installation

1. Remove back cover, as shown in the diagram below

• Insert and gently twist screwdriver into the slot at the top

and the bottom of the Control Interface. Do this procedure

alternately between the four slots until the back cover of the

control separates.

• Use large enough flat blade screwdriver to fit into the slot in

order to avoid damaging the Control Interface.

SLOTS

BACK COVER

3. Connect wiring at the back of Control Interface

• Ensure that all wiring is tightly connected. All wiring must be

in accordance with the provided wiring diagram.

WALL CONTROL WIRING

POWER: - BROWN / ORANGE

485 A:

- BLUE

485 B:

- BLUE-WHITE

GND:

- BROWN-WHITE / ORANGE-WHITE

NOT USED: - GREEN / GREEN-WHITE

5. Select zone buttons

• Remove the relevant zone buttons for zone name to be

allocated and attach to wall control.

• Ensure the buttons make a 'click' sound when attached to the

PCB casing.

BUTTON PAD

NOTE

Front cover can be removed even after installation. Press at

the bottom of the control interface and pull the front cover.

PCB CASING

SLOTS

BROWN-WHITE /

ORANGE - WHITE

BLUE / WHITE

BLUE

BROWN / ORANGE

POWER

485 A

485 B

GND

CUT OFF AND

DO NOT CONNECT

GREEN/GREEN-WHITE PAIR

PCB CASING

BUTTONS

BACK

COVER

LC7-2 Control Interface Insert

Document: 9590-3024 Ver. 2 200702

LC7-2 Control Interface

2. Mount back cover to the wall

• Mount the back cover to the wall with screws (not

supplied) via screw holes. If required, the use of a

plasterboard mounting bracket (not supplied) is

recommended to mount the back cover to the wall.

• Ensure that the Control Interface back cover is aligned

and leveled on the wall before tightening the screws.

LC7-2

BACK COVER

PLASTERBOARD

MOUNTING BRACKET

SCREW HOLES

4. Attach PCB casing to the back cover

• Attach the PCB casing by aligning with the back cover

mounted on the wall.

• Ensure the PCB casing makes a 'click' sound after

mounting.

BACK COVER

6. Attach the front cover, as shown in the diagram

below

• After attaching the front cover, check that the Control

Interface is aligned and leveled on the wall.

ZONE

BACK COVER

AS MOUNTED

ON THE WALL

PCB CASING

FRONT COVER