Cisco 2651 사용자 설명서 - 페이지 15
{카테고리_이름} Cisco 2651에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2651 48 페이지. Non-proprietary security policy
페이지 인쇄
WICs are similar to Network Modules in that they greatly increase the router's flexibility. A WIC is
inserted into one of two slots, which are located above the fixed LAN ports. WICs interface directly with
the processor. They do not interface with the cryptographic card; therefore no security parameters will
pass through them. WICs cannot perform cryptographic functions; they only serve as a data input and
data output physical interface.
The physical interfaces include a power plug for the power supply and a power switch. The router has
two Fast Ethernet (10/100 RJ-45) connectors for data transfers in and out. The module also has two other
RJ-45 connectors on the back panel for a console terminal for local system access and an auxiliary port
for remote system access or dial backup using a modem. The 10/100Base-T LAN ports have
Link/Activity, 10/100Mbps, and half/full duplex LEDs.
panel with descriptions detailed in
Figure 12
FastEthernet 0/1
FastEthernet 0/0
Table 8
LED
LINK
ACT
100 Mbps
CF1
Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, and 3745 Modular Access Routers and 7206-VXR NPE-400 Router FIPS 140-2 Non-Proprietary
OL-6083-01
The Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, 3745, and 7206 VXR NPE-400 Routers
Table
Cisco 2691 Rear Panel LEDs
S E E M A
N U A L B
E FO R E
D S U
IN S TA LL
AT IO N
5 6 K
A C T
10 0 M bp
s
LI N K
A C T
C F1
10 0 M bp
s
FA ST ET
HE RN ET
LI N K
0/ 1
FA ST ET
HE RN ET
0/ 0
CF1
LED
ACT LED
100 Mbps LED
LINK LED
Cisco 2691 Rear Panel LEDs and Descriptions
Indication
Description
On
An Ethernet link has been established
Off
No Ethernet link established
On
The interface is transmitting or receiving packets
Off
The interface is not transmitting or receiving packets
On
The speed of the interface is 100 Mbps
Off
The speed of the interface is 10 Mbps or no link is established
On
The Flash device is being accessed in either READ or WRITE mode
Off
The Flash device is not being accessed
Figure 12
shows the LEDs located on the rear
8:
S E E M A
N U A L B
D S U
E FO R E
IN S TA LL
AT IO N
5 6 K
C I S C O 2
6 9 1
Compact
Flash
Console
slot
S E E M A
N U A L B
E FO R E
IN S TA LL
AT IO N
CO NS O
LE
AU X
port
Auxiliary
port
15