Cisco 2691 Series 설치 및 포맷 - 페이지 7

{카테고리_이름} Cisco 2691 Series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2691 Series 34 페이지. Modular routers
Cisco 2691 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 사용자 설명서 (48 페이지), 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄

March 2002

Removing a Plug-in CPU/Mainboard

This section describes how to access a CompactFlash memory card mounted on a CPU/mainboard that

slides out of the chassis. You need a number 2 Phillips or flat-blade screwdriver to complete this

procedure.

Cisco 3745 routers have a plug-in CPU/mainboard.

Observe the following precaution if your router uses AC power:

Warning

Do not touch the power supply when the power cord is connected. For systems with a power

switch, line voltages are present within the power supply even when the power switch is OFF and

the power cord is connected. For systems without a power switch, line voltages are present within

the power supply when the power cord is connected. To see translations of the various warnings

that appear in this publication, refer to the Regulatory Compliance and Safety Information

document that accompanied this device.

Observe the following precaution if your router uses DC power:

Before performing any of the following procedures, ensure that power is removed from the DC

Warning

circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services

the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the

circuit breaker in the OFF position. To see translations of the various warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

Complete the following procedure to remove the CPU/mainboard from the chassis:

Power OFF the router. However, to channel ESD voltages to ground, do not unplug the power cable.

Step 1

The Cisco 3745 can have more than one power supply. Be sure that all power supplies are powered

Caution

OFF, and that the LEDs are all dark.

Place the router on a flat surface so that the front panel is facing you, and open the small access panel at

Step 2

the right-hand edge of the front panel.

Loosen the two captive screws located behind the access panel. (See

Step 3

Open the front panel to the straight-out position, and lift it off its hinges. (See

Step 4

Loosen the captive retention screws; there is one at each side of the CPU/mainboard. (See

Step 5

Pull the ejector levers at both sides, and carefully pull the CPU/mainboard straight out of the chassis.

Step 6

Place it on an antistatic surface. (See

When you are ready to reinstall the CPU/mainboard, refer to the

Step 7

CPU/Mainboard" section on page

78-13892-03

Figure

14.

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

Internal CompactFlash Memory Card Installation and Removal

Figure

9.)

"Reinstalling a Plug-in

8.)

Figure

8.)

Figure

9.)