Cisco 2691 Series 빠른 시작 매뉴얼 - 페이지 22

{카테고리_이름} Cisco 2691 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2691 Series 29 페이지. Modular routers
Cisco 2691 Series에 대해서도 마찬가지입니다: 설치 및 포맷 (34 페이지), 데이터시트 (8 페이지), 사용자 설명서 (48 페이지)

페이지 인쇄

For interface numbering information, see the "Interface Numbering" section on page 22.

Step 1

To proceed with manual configuration using the CLI, enter no.

Would you like to enter the initial configuration dialog? [yes/no]: no

Press Return to terminate autoinstall and continue with manual configuration.

Step 2

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

...

Compiled <date> <time> by <person>

Press Return to bring up the Router> prompt.

Step 3

...

flashfs[4]: Initialization complete.

Router>

Step 4

Enter privileged EXEC mode.

Router> enable

Router#

Note

To avoid losing work you have completed, be sure to save your configuration occasionally as you proceed. Use the

copy running-config startup-config command to save the configuration to NVRAM.

For configuration using the CLI, refer to the applicable configuration procedures in the Software Configuration Guide:

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers. See the "Where to Go Next" section on page 23 for

information about accessing this document.

Interface Numbering

Each individual interface (port) on a Cisco 2691 router is identified by number as described in the following sections.

WAN and LAN Interface Numbering

The Cisco 2691 router chassis contains the following WAN and LAN interface types:

• Built-in LAN interfaces: Ethernet, Fast Ethernet, Token Ring

• Two or three slots in which you can install WAN interface cards (WICs)

• One slot in which you can install a network module

The numbering format is Interface-type Slot-number/Interface-number. Two examples are:

• Ethernet 0/0

• Serial 1/2

The slot number is 0 for all built-in interfaces and 0 for all WIC interfaces; the slot number is 1 for network module interfaces.

Interface (port) numbers begin at 0 for each interface type, and continue from right to left and (if necessary) from bottom to top.

Figure 10 shows a router with:

• A 2-port T1 network module in slot 1 (containing the following ports: T1 1/0 and T1 1/1)

• Two built-in Ethernet 10/100 interfaces—Fast Ethernet 0/0 and Fast Ethernet 0/1