Cisco 3660 Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} Cisco 3660 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3660 Series 8 페이지. E1/t1 isdn pri network modules
Cisco 3660 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지), 데이터시트 (8 페이지)

페이지 인쇄

Chapter 4

Installation on Cisco 3660 Routers

Before performing any of the following procedures, ensure that power is removed from the DC

Warning

circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services

the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the

circuit breaker in the OFF position. To see translations of the warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that

accompanied this device.

Strip one end of the 6-AWG wire to expose approximately 0.75 in. (20 mm).

Step 2

Crimp the ground lug around the wire. (See

Step 3

Figure 4-7

Use the number 2 Phillips screwdriver to fasten the ground lug to the Cisco 3660 router chassis. (See

Step 4

Figure

78-5450-06 B0

Crimping the Lug Around the Wire

4-8.)

NEBS Level 3 and ETSI Compliance Kit Installation Guide for Cisco 3620, Cisco 3640, and Cisco 3660 Routers

Figure

4-7.)

Installing the Ground Lug

4-5