Cisco 3700 series 설치 및 포맷 - 페이지 4

{카테고리_이름} Cisco 3700 series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3700 series 34 페이지. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Cisco 3700 series에 대해서도 마찬가지입니다: 업그레이드 지침 (30 페이지), 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

Internal CompactFlash Memory Card Installation and Removal

Removing a CompactFlash Memory Card from an External Slot

Complete the following steps to remove a CompactFlash memory card from an external slot:

If the CF LED is lit or blinking, do not remove the CompactFlash memory card. The router might

Caution

reload, or the CompactFlash memory card can be damaged.

Locate the CompactFlash memory card in its slot in the front panel of the chassis. (See

Step 1

Figure

Move the release button, located next to the slot, to its fully extended position, and press the button to

Step 2

unseat the card.

Carefully pull the card out of the slot.

Step 3

Place the removed CompactFlash memory card on an antistatic surface or in a static shielding bag.

Step 4

Installing a CompactFlash Memory Card in an External Slot

Complete the following steps to install a CompactFlash memory card:

Locate the CompactFlash memory-card slot in the front panel of the chassis. (See

Step 1

and

With the label facing up, insert the connector end of the CompactFlash memory card into the slot until

Step 2

the card is seated in the connector and the release button is pushed out. The card is keyed so that it

cannot be inserted wrong.

Pull the release button out and move it to the left, to latch the card in the slot.

Step 3

Step 4

Refer to the

instructions on formatting the CompactFlash memory card.

Internal CompactFlash Memory Card Installation and Removal

Complete the appropriate procedure below for installing or removing a CompactFlash memory card

mounted internally on the CPU/mainboard. To access the internal CompactFlash memory card, you need

to either remove the chassis cover or slide the CPU/mainboard out, depending on the platform. For

Cisco 2691, Cisco 3631, and Cisco 3725 routers, refer to the

page

If you have questions or need assistance, see the

Internal CompactFlash memory card connectors are located as shown in

and

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

2, and

Figure

3.)

Figure

3.)

"Formatting Procedures for CompactFlash Memory Cards" section on page 20

9. For Cisco 3745 routers, refer to the

Figure

"Removing the Chassis Cover" section on

"Removing a Plug-in CPU/Mainboard" section on page

"Obtaining Technical Assistance" section on page

March 2002

Figure

for

Figure

78-13892-03

32.