Cisco 4000 Series 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco 4000 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4000 Series 18 페이지. Upgrading memory
Cisco 4000 Series에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 설치 준비 (11 페이지), 교체 매뉴얼 (16 페이지), 업그레이드 매뉴얼 (24 페이지)

페이지 인쇄

Mounting the Chassis in a Telco Rack

After you have installed the telco rack-mount or wall-mount brackets, take the following steps to

mount your system in a telco rack:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

This completes the telco rack-mount procedure.

Figure 16

Telco rack

10-32

machine

screws

Partially thread two 10-32 machine screws into one side of the telco rack with enough space

to allow one side bracket to ﬁt (see Figure 16).

While supporting the chassis shell, slip one side bracket over the two screws in place and

thread one screw in on the bracket on the opposite side to secure the shell to the telco rack.

Thread the remaining machine screw and tighten all the screws in place.

Replace the front panel by snapping it into the front of the chassis shell.

Reinsert the component tray into the shell.

Push on the back of the tray while at the same time pressing on the chassis release screw

(shown in Figure 1) with the thumb of your right hand.

Retighten the chassis release screw.

Telco Rack-Mounted Chassis

M3 machine screw

Mounting the Chassis in a Telco Rack

Front of the chassis

Cisco 4000 Series Rack-Mount and Wall-Mount Installation