Cisco 4000 Series 설치 매뉴얼 - 페이지 6
{카테고리_이름} Cisco 4000 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4000 Series 18 페이지. Upgrading memory
Cisco 4000 Series에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 설치 준비 (11 페이지), 교체 매뉴얼 (16 페이지), 업그레이드 매뉴얼 (24 페이지)
페이지 인쇄
Preparing the Chassis for Rack-Mounting or Wall-Mounting
Step 7
Step 8
Removing the Component Tray from a Chassis without a Safety Latch
Warning
working near the power supply. Before starting any of these procedures, turn OFF power to the
system, unplug the power cord, disconnect any cables at the ports, and attach your ESD-preventive
wrist strap.
Take the following steps to remove the component tray from a chassis without a safety latch:
Step 1
Step 2
Step 3
Step 4
Warning
hands, to prevent it from falling.
Figure 3
Chassis shell
6 Cisco 4000 Series Rack-Mount and Wall-Mount Installation
Set the component tray on your work surface.
Remove the plastic front panel from the front of the chassis shell by pulling it straight out
using both hands.
Hazardous voltages may exist in or near the power supply, so use extreme caution when
Turn OFF the system power.
Attach your ESD-preventive wrist strap.
Remove all network and power cables.
Loosen the nonremovable screw in the back of the router chassis. The screw is labeled
"Chassis release screw" in Figure 3.
Support the component tray from underneath, either on your work surface or with your
Component Tray Removal for Chassis Without a Safety Latch
Rear of chassis
Chassis release
screw
AUX
CONSOLE
Support the component
tray with your hand
INPUT 100-240VAC
50/60HZ 3.0-1.5 AMPS
Handle