Cisco 4000 Series 교체 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 4000 Series에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4000 Series 16 페이지. Upgrading memory
Cisco 4000 Series에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 설치 준비 (11 페이지), 설치 매뉴얼 (18 페이지), 업그레이드 매뉴얼 (24 페이지)

페이지 인쇄

Accessing the Power Supply

To access the power supply of a Cisco 4000 series router, you must ﬁrst remove the component tray.

Procedures for removing the component tray follow.

Some Cisco 4000 series routers have a safety latch tab on the chassis that affects removing the

component tray. (See Figure 3 and Figure 4.)

If your chassis has a safety latch tab, refer to the next section, "Removing the Component Tray from

a Chassis with a Safety Latch."

If your chassis does not have a safety latch tab, go to the section "Removing the Component Tray

from a Chassis without a Safety Latch."

Note

system console port, auxiliary port, and module ports appear to the left of the power cable and

switch. (See Figure 2.)

Removing the Component Tray from a Chassis with a Safety Latch

Warning

power switch, line voltages are present within the power supply even when the power switch is OFF

and the power cord is connected. For systems without a power switch, line voltages are present

within the power supply when the power cord is connected.

Take the following steps to remove the component tray from a chassis with a safety latch:

Step 1

Step 2

Step 3

Step 4

Warning

the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that

services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of

the circuit breaker in the OFF position.

Step 5

6 Replacing the Cisco 4000 Series Power Supply

The power cable and power switch are on the lower right of the rear panel of the router. The

Do not touch the power supply when the power cord is connected. For systems with a

Turn OFF the system power.

Attach your ESD-preventive wrist strap.

Remove all network cables. Proceed with Step 4 if you have an AC power supply. Proceed

with Step 5 if you have a DC power supply.

If you have an AC-powered router, remove the power cord.

Before performing any of the following procedures, ensure that power is removed from

If you have a DC-powered router, take the following steps to remove the power cables:

Use a screwdriver to loosen the captive installation screws on the terminal block

(a)

cover.

(b)

Lift and remove the terminal block cover.

(c)

Use a screwdriver to remove the three power leads from the terminal block in the

following order: negative, positive, then ground.