Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 설치 참고 사항 - 페이지 30

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 설치 참고 사항 (46 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 매뉴얼 (19 페이지)

Removing and Installing Ethernet Modules in the Chassis

Fully open both ejector levers on the Ethernet module. (See

Step 3

Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the

Step 4

following two sets of substeps:

Horizontal slots

Position the Ethernet module in the slot. (See

module carrier with the slot guides on each side of the slot.

Carefully slide the Ethernet module into the slot until the EMI gasket along the top edge of the

module makes contact with the module in the slot above it and both ejector levers have engaged and

closed to approximately 45 degrees with respect to the Ethernet module faceplate. (See

Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create

a small (0.040 inch [1 mm]) gap between the module's EMI gasket and the module above it. (See

Figure

Do not press down too hard on the levers because they can bend and be damaged.

Caution

While gently pressing down, simultaneously close the left and right ejector levers to fully seat the

Ethernet module in the chassis backplane connector. The ejector levers are fully closed when they

are flush with the module faceplate. (See

Note

Tighten the two captive installation screws on the Ethernet module.

Note

Verify that the Ethernet module STATUS LED is lit. Check the STATUS LED periodically. If the

STATUS LED changes from orange to green, the module has successfully completed the boot

process and is now online. If the STATUS LED remains orange or turns red, the module has not

successfully completed the boot process and may have encountered an error.

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

20.)

Failure to fully seat the module in the chassis backplane connector can result in error

messages.

Make sure that the ejector levers are fully closed before tightening the captive installation

screws.

Figure

19.)

Figure

19.) Make sure that you align the edges of the

Figure

21.)

Figure

20.)

OL-24918-02