Cisco 7100 Series 빠른 시작 매뉴얼 - 페이지 17
{카테고리_이름} Cisco 7100 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7100 Series 25 페이지. Field-replaceable units in vpn routers
Cisco 7100 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (21 페이지)
페이지 인쇄
Start the System
Check Conditions Prior to System Startup
Check the following conditions before you start your router:
•
Any port adapter or service module is securely inserted in its slot.
•
All network interface cables are connected.
•
A Flash Disk or Flash memory card is installed in its PC Card slot.
•
The power cable is connected (for dual power supplies, the cable-retention clip is secured).
•
The console terminal is connected and powered on.
Start the System
1
At the rear of the router, place the power switch on the power supply in the on (|) position.
The green power LED on the router goes on.
2
Listen for the fans; you should immediately hear them operating.
3
During the boot process, observe the system LEDs. The LEDs on most of the fixed
interfaces and port adapters go on and off in irregular sequence.
4
Observe the initialization process. When the system boot is complete (a few seconds), the
network processor begins to initialize the interfaces. During this initialization, the LEDs on
each port behave differently (most flash on and off). When initialization is complete, the
enabled LED on each interface goes on.
Note: For more information on LEDs, refer to the "System LEDs and Reset Button" section
in Chapter 1, "Cisco 7100 Series Product Overview," in the Cisco 7100 Series VPN Router
Installation and Configuration Guide.
15