Epson H421F 빠른 설정
{카테고리_이름} Epson H421F에 대한 빠른 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson H421F 4 페이지.
페이지 인쇄
PowerLite
Home Cinema 3010+
®
Quick Setup
Before using the projector, make sure you read the safety instructions in the
online User's Guide (may require an Internet connection).
Choose a location
Keep the projector level and place it at a height where its lens is centered
between the top and bottom of the screen. If this isn't possible, use the
horizontal keystone slider and keystone correction buttons to reposition the
image (see "Adjust the image").
In order to view 3D images correctly, 3D glasses must be worn within proper
range of the projector. Use the image below to determine the ideal distance for
3D projection (the shading represents the 3D viewing area):
60º
13 ft (4 m)
Use the optional external 3D emitter if the projector is located over
16.5 feet (5 m) from the viewing area. See "Optional accessories" on the
back of this sheet for ordering information, and the User's Guide for more
information on where to place your projector.
Connect the projector
Choose from the following connections. See the sections below or the User's
Guide for details.
Video Device
Connect up to 5 video devices and use the Source buttons on the projector or
the remote control to switch between them.
*412172600*
*412172600*
16.5 ft (5 m)
HDMI cable
RCA Video cable
Audio cable
Component video cable
Audio cable
Computer
Monitor Port
Connect one end of a VGA cable to the projector's PC port, and the other end
to your computer's
monitor port. If you are using a laptop, switch it to
external display (see "Troubleshooting"). You can also connect an audio cable.
HDMI Port
Connect one end of an HDMI cable to the projector's HDMI port and the other
end to an HDMI port on your computer.
Camera or USB Device
Connect a digital camera, USB flash drive, or USB storage device to the
projector's
USB port.
USB port.
If you connect a digital camera, USB flash drive, or USB storage device, you can
use the projector's Slideshow feature to project images. See the User's Guide for
details.
Turn on your equipment
1
Turn on your video source or computer.
2
Plug in the projector. The
3
Remove the lens cap.
4
Press the
power button on the projector or On button on the remote
control. The power light flashes blue, and then stays on.
Note: To shut down the projector, press the
projector twice or the Standby button on the remote control, then
unplug it. You don't have to wait for the projector to cool down.
5
The default language of the menu system is English. To select another
language, press the Menu button on the remote control. Select Extended
and press Enter. Select Language and press Enter. Select your language
and press Enter. Press the Menu button to exit the menu system.
HDMI cable
VGA cable
power button on the projector turns blue.
power button on the