Epson Home Cinema 2100 조립 지침
{카테고리_이름} Epson Home Cinema 2100에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Home Cinema 2100 13 페이지. Ink system eco-flo continuous ink system permajet
Epson Home Cinema 2100에 대해서도 마찬가지입니다: 빠른 설정 (4 페이지)
페이지 인쇄
IMPORTANT
If your printer is new, set it up according to
the enclosed manufacturers instructions.
This is a check to ensure your new printer
and drivers are working correctly before the
Eco-Flo System is installed.
It is very important you read these instructions carefully before you begin!
We will take you through the following steps:
1
Preparing your Injector
2
Setting up of the Inks in the bottle tray
3
Installation of the modified injector to your printer
4
Fitting of the Tube Supports System
5
Producing your first print.
Only start work on the installation once you have read the
What you will need to Install the Eco-Flo 2100
•
Complete Eco-Flo 2100 Kit
•
Sharp Blade (Stanley Knife type) & Scissors
•
Measuring Tape or Ruler
•
Marking Pen or Pencil
•
Paper Towels
Please read carefully before you continue and
refer to the components diagram over the
page.
Check List for components
Assembly Instructions for
EPSON PRINTER
instructions fully!
Set of 7
125ml Inks
ECO-FLO CONTINUOUS INK SYSTEM
2100 Ink System
:
What is included in your Eco-Flo 2100 Kit
•
Injector Set with tubes attached
•
Set of 7 Inks & empty 100ml bottles
•
Black Tube Support Bracket with Hook &
Loop Fastener fitted
•
Bottle Holder Tray
•
Special Chip Block
•
1 Grey/White Tube Clip with adhesive pad
•
Installation Instructions and Profiles CD
•
10ml Syringe & wing adaptor
•
Pair of latex gloves
•
Special Foam Block
•
7 Tube Clamps
•
7 Bottle Caps & Clear Piping Tubes
1
Wing Adaptor
Perma
Jet
Epson 2100
Part No. A26421
Epson 2100 Eco-Flo Shown
Black Tube
Support Bracket
.