Epson PhotoPC 550 매뉴얼 - 페이지 5
{카테고리_이름} Epson PhotoPC 550에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson PhotoPC 550 13 페이지. Epson photopc 550: specifications
페이지 인쇄
Using Macro Mode to Take Close-ups
You can use the camera's macro mode to take pictures as close
as 3.9 inches (10 cm). The macro range is from 3.9 to
21.7 inches (10 to 55 cm). Follow these steps:
1. Turn the camera on.
2. Slide the macro switch so it is above the macro icon.
macro switch
3. The macro icon appears on the display panel.
macro icon
4. Center the image in the viewfinder and press the shutter
button to capture it.
TIP
When centering your image, be sure to leave space around the image
to compensate for any parallax shift (the difference between what
you see in the viewfinder and the actual image captured).
5. To turn off macro mode, slide the macro switch to the left.
The macro icon disappears from the display panel.
macro icon
macro crop
marks
actual image
area captured
Taking Pictures in Low Light
Conditions
You can use PhotoPC 550 in most indoor or low light
settings. There is no need for a flash because of the camera's
highly light sensitive CCD. A good rule of thumb is if you can
read a book in the available light, you can take a picture with
PhotoPC 550.
When taking pictures in low light conditions, be sure to hold
the camera still until you hear it beep. The shutter speed may
be as slow as 1/4 of a second in low light conditions. You can
use a tripod to hold the camera steady. See "Using a Tripod"
on page 6.
Taking Pictures With the Self Timer
Setting the self timer adds about a 10-second delay between
the time you press the shutter button and when the picture is
taken.
Follow these steps to take a picture with the timer:
1. Secure the camera on a flat surface or on a tripod. (See the
next section for information on attaching the camera to a
tripod.)
2. Turn on the camera and wait until the status light turns
green.
3. Press the
SELF TIMER
the display panel.
4. Press the shutter button. The timer icon on the display
panel flashes slowly for about 8 seconds. Then the icon and
the timer light (on the front of the camera) flash rapidly for
about 2 seconds before the shutter is released.
The camera beeps when the image is captured. The status
light continues to flash red as PhotoPC 550 processes the
image. When the status light stops flashing and turns green,
you can take another picture.
The timer automatically turns off after the image is processed
or if you turn the camera off and back on.
10/8/97
EPSON PhotoPC 550
button. The timer icon appears on
self timer icon
PhotoPC 550 - 5